How do I require items to be verified (by click or scan) before printing a label in Scan to Print?

Last updated: November 9, 2026

Scan to Print's Verify and print mode has two optional settings that stop a label from printing until the order's items have been checked.

Choose a setting

Go to Settings > Fulfillment, then click Save Settings after changing either toggle:

  • Require every item verified before printing: the label prints only after each item is verified, either by scanning it or by clicking Verify on the line (or Mark all verified). Use this if many of your items have no barcodes.

  • Require every item scanned before printing: the label prints only after each item is scanned. The manual Verify buttons are hidden.

Because scanning every item also verifies every item, the verify toggle shows as on and locked while the scan setting is on. Your saved verify value is kept. It becomes editable again if you turn the scan setting off.

What packers see

  • With either setting on, the Verify items panel hint says the label prints once every item is verified (or scanned).

  • Until all items are checked, printing is blocked with a message such as "Verify the remaining 2 items before printing." If scanning is required, it says "Scan" instead.

  • With both settings off, verification is only a check and you can print without it.

Orders with the same SKU on several lines

If an order has the same SKU on more than one line, Verify items shows one row for that SKU with the combined quantity. Scanning or clicking Verify on that row covers all of those lines. The order's underlying lines are not changed.

Ship-to address

The Verify and print header shows the full ship-to address (recipient, street, city line) so it can be checked before buying the label.