How do I correct the lots consumed on a completed assembly order?

Last updated: November 9, 2026

You can change the lots consumed by a completed assembly order without deleting or rolling it back. This is done in the same Correct quantities dialog used for quantity fixes. See the article on fixing wrong produced or consumed quantities for the basics and permission requirements.

Before you start

  • The order must be Completed and must be an assembly order. Lots can't be corrected on disassembly orders.

  • The component must be lot tracked, and inventory must be tracked by location.

  • You need the permission to correct completed assembly orders.

  • Check your accounting period. Lot corrections post as of today.

Steps

  1. Open the completed order and click Correct quantities.

  2. For a lot-tracked component, pick a different lot from the Lot dropdown. The dropdown shows the quantity available in each lot.

  3. To split a component across lots, click + Lot on the line. Choose the other lot and enter its quantity.

  4. To remove a line's consumption, set its quantity to zero.

  5. Under Today's on-hand, choose:

    • Move today's on-hand by the difference: the shelf holds the corrected amount.

    • Keep today's on-hand — post a balancing adjustment: today's count is already right; only the history was wrong.

  6. Click Confirm.

What happens

  • Stock is returned to the old lot and taken from the new lot, so lot running balances and the lot movement report update.

  • The order's lines are updated, and the change is recorded in the order history as a quantity correction.

Limits

  • If the new lot doesn't have enough on hand at that location, the correction is refused and nothing changes. The message names the lot and how much is short.

  • You can't put two lines of the same product on the same lot.

  • Correct a component's lots and its other quantities in separate corrections.

  • Cost is not recalculated. Line cost, cost layers and shipped COGS stay as they were.

  • If your account uses Luminous Core, a lot change that also changes the product's total on-hand is refused. Keep the total the same and change only which lots were used.